Koro tabletop device

File	User manual Vencube beta currently only in German
Download link	BA_Vencube_beta_032020.pdf

Installation instructions

For VenCube installation position, see Image 2. The VenCube service keyboard can be accessed by removing the coffee bean insert (Image 3). The location and connection of the transformer can be seen in Figures 4 and 5, the additional wiring in Figures 6 to 8. The connection lines and the antenna must be removed for the installation of the VenCube, the openings and bores for the lines to pass through are too small. Picture 9 shows the installation position of the antenna. The required conversion kit can be ordered from Necta. The serial number can be ordered on request and placed in the inner door next to the mechanical counter. Only carry out the conversion if you are familiar with electrical engineering and observe the VDE regulations. After successful installation, the VenCube still has to be updated with software 98.40 if no payment system is available, if this has not already been ordered. If other software is installed on the VenCube and the VenCube is operated without a payment system, the message "No change" appears on the machine's display.

Type plate (image 1) Vencube service keyboard (image 3) transformer (image 5) Cable set (image 7) back (image 9)

Vencube above (image 2) open on the right (image 4) open back (image 6) Connection (image 8) Door inside (image 10)